New motor for the Tantrum
#1
Registered
Thread Starter
Join Date: Oct 2007
Location: marbury, md
Posts: 1,224
Likes: 0
Received 0 Likes
on
0 Posts
New motor for the Tantrum
Its finally done. Still needs paint. We dynoed it yesterday and made 693hp at 5500 rpm through 5700 rpm, 733 tq at 4500 rpm.
Its a 555ci gen. 4, bowtie tall deck roller motor. Merlin 320 iron heads w/ little work, 1050 dominator, 9.6-1 comp. ratio, 26* timing on 93 pump gas.
Maybe I will sqeeze in a sea trial befor it gets too cold...
http://www.youtube.com/watch?v=n27pZlc7BI8
I thought this was cool too, turn up your volume
http://www.youtube.com/watch?v=Nxsxjc1SMpE
Its a 555ci gen. 4, bowtie tall deck roller motor. Merlin 320 iron heads w/ little work, 1050 dominator, 9.6-1 comp. ratio, 26* timing on 93 pump gas.
Maybe I will sqeeze in a sea trial befor it gets too cold...
http://www.youtube.com/watch?v=n27pZlc7BI8
I thought this was cool too, turn up your volume
http://www.youtube.com/watch?v=Nxsxjc1SMpE
#4
Registered
Thread Starter
Join Date: Oct 2007
Location: marbury, md
Posts: 1,224
Likes: 0
Received 0 Likes
on
0 Posts
No blower, all motor. We tried 29* but there was no increase, that is the pull in the video. Not sure on the egt, but the a/f was good. I will check my sheets for egt.
#9
Registered
Thread Starter
Join Date: Oct 2007
Location: marbury, md
Posts: 1,224
Likes: 0
Received 0 Likes
on
0 Posts