26 nsx pics boat was striped down and redone front to back project almost done.

outlaw26 · 07-20-2009, 09:06 PM

DSCF0410.JPG

DSCF0398.JPG

DSCF0412.JPG

DSCF0415.JPG

crowntow · 07-21-2009, 05:45 PM

That looks good.Do you have any before pics?

outlaw26 · 07-21-2009, 10:54 PM

I did not take any before shots wish I would of it had a lot of cosmedic damage deep scrathes a couple of feet down the side. And the interior and engine bay was nasty.

Rottiguy · 07-22-2009, 10:47 PM

looks great, Im doing a NSX right now. I would post some pics but i guess my membership ran out or something.

outlaw26 · 07-23-2009, 07:01 AM

Thamks I can't wait to get it wet. I'm anxious to see how its going to run

Catmando · 07-23-2009, 03:46 PM

Good job on the resto!

What motor and drive?

outlaw26 · 07-23-2009, 05:56 PM

Quote:

Originally Posted by Catmando

Good job on the resto!

What motor and drive?

Thanks its been a slow project. The motors the last step I'm hoping to have it done before the summers over. I'm building a blown 598 dart block and heads,with a 16-71 on top, for the drive I custom painted an imco sc and extention box to macth the trailer and boat. I'm doing the best I can on a small budget.

LuvMy47Ftn · 09-07-2010, 11:41 PM

It's been a little over a year now and very curious how this baby turned out?

Catmando · 05-02-2011, 11:30 PM

Quote:

Originally Posted by outlaw26

Thanks its been a slow project. The motors the last step I'm hoping to have it done before the summers over. I'm building a blown 598 dart block and heads,with a 16-71 on top, for the drive I custom painted an imco sc and extention box to macth the trailer and boat. I'm doing the best I can on a small budget.

C'mon outlaw what's the scoop now? And that IMCO drive...I wouldn't bang on it too much if I were you because you'll probly be right at its limits with that monster motor...

outlaw26 · 05-03-2011, 12:12 AM

Hoping to see some dyno time early next week, put a psi on top rather than the 16-71, and went with imcos 4x4 drive with the tranny in the extension box, sent it to imco and put new upper and lower gears and bearings. im hoping to have it together in time to make the Chattanoga fun run.