Rubber bushing for nose of Bravo 1 drive
#1
Registered
Thread Starter
Join Date: Jan 2005
Location: Lake Champlain
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Rubber bushing for nose of Bravo 1 drive
1988 Formula-F-311, 454 mag - 365hp.. I just pulled the Bravo-1
out-drive and and engine, port side, and noticed a deteriorated rubber bushing that existed in the flywheel. Was this intended for the tip of the Bravo input shaft? I have a thread and some pics of this engine removal in the Formula forum under 311 rebuild. Thanks for any help / advice that you can offer.
out-drive and and engine, port side, and noticed a deteriorated rubber bushing that existed in the flywheel. Was this intended for the tip of the Bravo input shaft? I have a thread and some pics of this engine removal in the Formula forum under 311 rebuild. Thanks for any help / advice that you can offer.
Last edited by QUIKDECISION; 04-27-2005 at 07:13 PM.
#3
Re: Rubber bushing for nose of Bravo 1 drive
I looked at your other pictures in the Formula thread but they don't show what you are talking about . if you could post a pisture I'm sure it can be identified.