wingplate stud supplier
#1
Registered
Thread Starter
Join Date: Feb 2004
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
wingplate stud supplier
Does anyone know the specs and/or a supplier for the longer studs to attach a wingplate to a #3,4,5 I believe they are circa 5 3/8" and each drive would require 4. The next question is best method of removal! Thanks Dave
#2
Registered
Join Date: Dec 2000
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
Re: wingplate stud supplier
I just mounted a wing plate. I bought stainless bolts with the course threads ,I think they were 5/16ths. They were 4" bolts but only threaded about 1 to 1 1/2". Cut the bolt to the length I needed and threaded with the fine threads of the mounting bolts.
#3
Charter Member #94
Charter Member
I hate the "cut to fit" idea. Who did Mayfair / Marine Machine get their drive studs from? (since they don't seem to be able to get them either)
__________________
Abby-someone
Abby-someone
#5
Registered
Platinum Member
Mcmaster Carr has a good selection of stainless studs. http://www.mcmaster.com/#standard-threaded-rods/=or3bhe
Thread
Thread Starter
Forum
Replies
Last Post
onesickpantera
General Boating Discussion
2
06-08-2005 10:31 PM