Billet Drive Caps
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Dec 2001
Location: Orlando, Fl
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Billet Drive Caps
Ok, how difficult is it to install a billet drive cap, like the Teague or equivalent?
Does it take a drive mechanic, or can Joe-weekender do it?
Do you know if you have to shim the bearings or anything like that?
Any suggestions on which cap is best?
Thanks.
Does it take a drive mechanic, or can Joe-weekender do it?
Do you know if you have to shim the bearings or anything like that?
Any suggestions on which cap is best?
Thanks.
#3
Platinum Member
Platinum Member
Thread Starter
Join Date: Dec 2001
Location: Orlando, Fl
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: Billet Drive Caps
I moutned a pair of the ITS drives on my hp transom plate, so I am still using the latham steering and end caps.
The ITS drive caps have an integral tie-bar mount that simply leaves a large, unsued hole on the aft end of the cap.
Maybe I'll just mount another drive shower there...
The ITS drive caps have an integral tie-bar mount that simply leaves a large, unsued hole on the aft end of the cap.
Maybe I'll just mount another drive shower there...
#4
Re: Billet Drive Caps
How about a Billet Cap with a built in drive shower?
$299.95 ea, includes bearings.
www.getrealperformance.com
805-968-6122
$299.95 ea, includes bearings.
www.getrealperformance.com
805-968-6122
#5
Charter Member #601
Charter Member
Re: Billet Drive Caps
34Scarab,
I always measure the cap to make sure it is the same as the one removed. There are differences, believe me.. I have seen them. Most are pretty close to stock, some are not.
One choice you have is the new XR cap that looks like your ITS cap, but without the tail and hole! It also has a steel tower and they are real reasonable..
Dick
I always measure the cap to make sure it is the same as the one removed. There are differences, believe me.. I have seen them. Most are pretty close to stock, some are not.
One choice you have is the new XR cap that looks like your ITS cap, but without the tail and hole! It also has a steel tower and they are real reasonable..
Dick
Thread
Thread Starter
Forum
Replies
Last Post
teaguecustommarine
New Products and Member Discounts
39
06-23-2008 01:05 PM