Finally Need Break In Advice
#1
Finally Need Break In Advice
I think my motors might be ready to light this weekend and I want to know how to break them in. Stock 454mag bottom with no changes and added Brodix custom ported aluminum heads, cam motion roller cams, crane roller lifters, roller rockers, Dana headers, Weiand 177 blower with a Quick Fuel boost referenced and modified single carbs , boost should be 5 lbs., MSD ignition going to set a 30 deg total advance.
Since the bottom is already broken in how do I break this in? What kind of oil, do I need to use regular oil or do I go right for the synthetic from the start?
Advice is appreciated, I will post pictures as soon as I can. Hopefully all will go well.
Since the bottom is already broken in how do I break this in? What kind of oil, do I need to use regular oil or do I go right for the synthetic from the start?
Advice is appreciated, I will post pictures as soon as I can. Hopefully all will go well.
#2
Registered
Join Date: Jul 2004
Location: SENECA LAKE
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Re: Finally Need Break In Advice
I just did basically the same thing but on a small block. I used Trick Flow aluminum heads and they said easy for 2 hours. Best to call Brodix and ask how they want you the run in the heads. Don't forget to check your rocker arm geometry to make sure the push rods are the correct length.
#4
Registered
Join Date: Jul 2004
Location: SENECA LAKE
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Re: Finally Need Break In Advice
Trick Flow said to use non synthetic for the first hours before switching to synthetic so the oil you normally use should be OK unless its Syn. When I do a complete rebuild I break in on 30 Wt. non detergent.