Windshields fo 26' 1996 AO NSX
11-25-2005, 08:40 PM
#3
Platinum Member
Platinum MemberThread Starter
Join Date: Oct 2003
Location: Boca Raton Florida
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
Re: Windshields fo 26' 1996 AO NSX
Good idea. What did you cut it out with for a smooth edge? Where did you buy the plexiglass?
11-25-2005, 08:52 PM
#4
Registered
Join Date: Mar 2002
Location: Canton, GA
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: Windshields fo 26' 1996 AO NSX
I used lexon plexiglass because its stronger and i got it at at place near my house. I traced it out and cut it with a jig saw and smoothed it out with a sander. Not sure where you can get it but im sure you can either find a place near your area or get it on the internet.
Dave.
Dave.
11-27-2005, 12:10 PM
#5
Platinum Member
Platinum MemberThread Starter
Join Date: Oct 2003
Location: Boca Raton Florida
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
Re: Windshields fo 26' 1996 AO NSX
Thanks. BS. I'll try that. I just replaced starboard side so I'll have a pattern to trace. When I bought the boat it came with 2 replacements. Is port the same as starboard? Are the holes drilled in the same spots?
11-27-2005, 01:52 PM
#6
Registered
Join Date: Mar 2002
Location: Canton, GA
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: Windshields fo 26' 1996 AO NSX
No there probally not the same. Match the holes up with your other windshield. Drill about 6 holes 2 on each side amd 2 on the front. Put the windshield on with some one holding it and drill the other holes with the windshield on the boat. Make sure you use lexon. The other plexiglass wont bend as easy.
Thread
Thread Starter
Forum
Replies
Last Post
jrodnj
General Boating Discussion
12
01-01-2007 09:26 PM
