29scarab

a Bravo 1 outdrive and the so called bellhousing. Putting a BRavo 1 on for the first time and want to make sure I don't miss anything. I see where the shifter cable latches in , but wanted to make sure there is not a gasket that belongs between them.


I wanted to thank JOE at KI Performance marine and the other guys on the board for helping me answer the questions I need to get my boat back together. I'm going to try to fire the engine this weekend for the first time in the boat after the boat sitting a year!!

Thanks,
shawn

98itrwhite

there's a set of o-ring type gaskets that go in there. its called a bravo one gasket kit and sells at the dealer for about 8 bucks. hope this helps good luck

29scarab

Thanks 98 for the input!!

GOODT

all that goes there are the o rings I like to put alittle gorrila snot ( 3m super weather strip adhesive ) on them to be sure they dont move while installing the drive

29scarab

GOODT,

I'm back to working on the boat again tonight. I put the outdrive on the other night and can't remember if I saw them or not, so I'm pulling the outdrive again to make sure everything is in the right spot!!

Thanks guys!!!