mcm 350 mag misses at WOT
#1
Registered
Thread Starter
Join Date: Jul 2006
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
mcm 350 mag misses at WOT
I have a MCM 350 magnum 4bbl, I've rebuilt the carb, new plugs, wires cap, rotor, coil, the boat runs excellent starts good lots of power put the throttle right down and it slams you in the seat til 45mph then it starts missing and sputtering pull back to 3/4 no proplem it keeps pulling soon as you hammer it down again it does it agian.
Jamie.
Jamie.
#4
Gold Member
Gold Member
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
Re: mcm 350 mag misses at WOT
Seems like it is running the bowls dry,check floats,does it do it all the time?
Could be timing too if it does it every time.
Could be timing too if it does it every time.
#5
Registered
Join Date: Apr 2005
Location: KENT ISLAND, MARYLAND
Posts: 2,675
Likes: 0
Received 0 Likes
on
0 Posts
Re: mcm 350 mag misses at WOT
be sure to check both base and total timing
also check your firring order to the plugs ( more then likly this is not the problem since it runs fine at lower end but worth checking)
is it a q jet, AFB, or holley carb ??????
let us know how you make out
also check your firring order to the plugs ( more then likly this is not the problem since it runs fine at lower end but worth checking)
is it a q jet, AFB, or holley carb ??????
let us know how you make out
#6
Registered
iTrader: (1)
Re: mcm 350 mag misses at WOT
Probably carb, fuel filters, or fuel pump.
Rebuilt does not always mean 'working properly' unfortunately.
Rebuilt does not always mean 'working properly' unfortunately.