u joint life.
#1
Registered
Thread Starter
u joint life.
I changed my drive and since I have a ITS extension system, I had to change over the long drive shaft that goes into the boat over to the new drive. The ujoints that were on the drive were in good shape but were hard to press out and took a little finness with the hammer to go back in. One of the keepers did not lock in very easy. All turnes well and looks good, Any concernes with how long before changine ujoints on the drive?
#2
Registered
Join Date: Aug 2004
Location: Sunny, AZ
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
Re: u joint life.
Probably should have just installed a new one from the get go, if one of the caps won't lock you might have slighly bent one of the yokes during disassembly/assembly process or one of the many bearing in the caps fell over and not letting the cap fully seat.
#6
Registered
Join Date: Apr 2005
Location: KENT ISLAND, MARYLAND
Posts: 2,675
Likes: 0
Received 0 Likes
on
0 Posts
Re: u joint life.
Originally Posted by FOUNTAINATLAST
Most likely not but you need the lock clip in place or the u-joint may come apart which won't do your bellows or yokes any favors...
or Transom assy for that matter.....when a ujoint goes it can get VERY messy
#9
Re: u joint life.
Originally Posted by GOODT
or Transom assy for that matter.....when a ujoint goes it can get VERY messy
thank god for a twin engine boat!
Thread
Thread Starter
Forum
Replies
Last Post
powerquest280
Drives and Lower Units
12
07-09-2008 09:16 AM