Put drive on and now starter grinds
#1
Registered
Thread Starter
Put drive on and now starter grinds
Trs drive was real hard to get on the last 1/2 inch. Now that the drive is installed every other time i go to start the engine the starter will grind. If i click it a couple of times the bendix will engage totally and crank the engine. What would cause this? Drive shaft pushing against tranni and that pushing flywheel??
#2
Platinum Member
Platinum Member
Join Date: Jun 2004
Location: St-Hyacinthe, quebec, canada
Posts: 7,726
Received 368 Likes
on
247 Posts
Re: Put drive on and now starter grinds
Hard to tell. The drive shaft goes in the trannie but this part as far as I know does not spin unless you engage the transmission. So I don't see why it would give a hard time to the starter to turn the engine. So, I would guess a starter problem.
Anyboby else? I'm just a beginner with TRS on my boat...
Anyboby else? I'm just a beginner with TRS on my boat...
#6
Re: Put drive on and now starter grinds
you may only have shims if the starter is mounted to the block like it would be on a car/truck application. Most TRS setups i've seen or dealt with had the starter mounted on the top/rear of the bell-housing......installing the outdrive shouldn't have any affect on the starter or flywheel....there's something else causing you problems...maybe the starter bolts are loose...or a chipped tooth on the flywheel....or the starter itself is going bad...
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
Thread
Thread Starter
Forum
Replies
Last Post
fastboy
General Boating Discussion
5
08-30-2007 09:01 PM
nobudget
General Q & A
2
04-21-2002 09:53 PM