OK guys, the motors are out.......
#1
Registered
Thread Starter
OK guys, the motors are out.......
the motors are out (for a repower and a bilge re do), the drives are off, the boat is 18 yrs old........should I take the gimble housings off and reseal?? how hard is that to do??......anything else you would do while its all apart?? twin 350/alpha 1s
thanks doug
thanks doug
Last edited by pullmytrigger; 04-16-2007 at 08:35 AM.
#2
Registered
iTrader: (3)
if your that far along..go for it..its not that hard, givin the age I wiould pull everything off the transom and reseal..an ounce of prevention prevents a ton of girnding, itching ,scatching and money in the future. I redid a transom once..notice I said once, wasnt what I would call fun.
#4
Registered
The tranon to transom assembly doesn't leak too often.
I would check for any play in the upper/lower swivel pins. It's probably worth the effort to replace the upper pin seals and bearing since these are the most problematic.
I would check for any play in the upper/lower swivel pins. It's probably worth the effort to replace the upper pin seals and bearing since these are the most problematic.
Thread
Thread Starter
Forum
Replies
Last Post
302Sport
General Boating Discussion
22
09-19-2008 01:19 PM
32 thunder
General Boating Discussion
17
07-09-2005 10:09 AM
razor1115
General Q & A
4
03-25-2004 11:13 PM