Garmin Gps 2010c To Livorsi Gps Speedo
06-08-2007, 01:23 PM
#1
Registered
Thread Starter
Join Date: Sep 2006
Location: sweetwater, nj
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Garmin Gps 2010c To Livorsi Gps Speedo
I Installed A Livorsi Speedo For My Back Seat And Want To Wire It Up To My Garmin 2010c Gps, Anyone Know How I Should Do This?
06-08-2007, 01:48 PM
#2
Registered
I have the Garmin 3210c and this is how mine worked:
The Garmin 3210 has a 4 National Marine Electronics Association (NMEA) ports. Port 4 ( is reserved for the antenna, port 3 is reserved for the sonar. Port 1 (pin 16/brown data in and pin 17/blue data out). Port 2 (pin 9/violet data in and pin 10/gray data out). You can use either of these ports to go to the input of your speedo. I have smartcraft and it was a blue/white input to the smartcraft system- not sure what wires your speedo has?
page 76: http://www8.garmin.com/manuals/41_OwnersManual.pdf
This has your unit
http://www8.garmin.com/manuals/47_20...stallation.pdf
The Garmin 3210 has a 4 National Marine Electronics Association (NMEA) ports. Port 4 ( is reserved for the antenna, port 3 is reserved for the sonar. Port 1 (pin 16/brown data in and pin 17/blue data out). Port 2 (pin 9/violet data in and pin 10/gray data out). You can use either of these ports to go to the input of your speedo. I have smartcraft and it was a blue/white input to the smartcraft system- not sure what wires your speedo has?
page 76: http://www8.garmin.com/manuals/41_OwnersManual.pdf
This has your unit
http://www8.garmin.com/manuals/47_20...stallation.pdf
Last edited by marylandmark; 06-08-2007 at 01:50 PM.
06-08-2007, 01:57 PM
#3
Registered
