lilredboat

OK, did the heads, exhaust, roller rockers, programmed ECU, now have a nasty idle surge dropping from 500 - 110 rpm. Tried adjusting both throttle blades, playing with fuel pressure and nothings working. Anyone ever fix this before?? Please Help! Thanx!

HiPerf2000

iTrader: (2)

did you forget to mention a blower ???

Pwrbt33

iTrader: (2)

I have had this happen before when we had the ecm reprogrammed. Once I had to just let it run and idle for damn neer ever and the other I had to send it back to have them fix it.

john

lilredboat

no blower, and i clocked about 2 hours on the hour meter on the hose, does it really take that long???

HiPerf2000

iTrader: (2)

Thought a whipple was going on ??

BenPerfected

Did you do an porting work on the intake manifold?

mjb

Sounds like your IAC needs adjusting. That is usually needed after reprogramming your ECM. You will need a scan tool. Make sure your base timeing and fuel pressure are set correct to begin with. Then after the engin warms up, set the IAC to about 35 to 40 counts by adjusting the stop screw on the promary throttle blade. That more than likely will solve your problem....assuming your IAC is in good working order. If that doesn't work you may need to check the calibration of your TPS....but we'll save that for another thread.