Help? Bravo 1 Question
#1
Registered
Thread Starter
Join Date: Jul 2002
Location: pa
Posts: 2,233
Likes: 0
Received 0 Likes
on
0 Posts
Help? Bravo 1 Question
Was Running In A Poker Run Saturday Pretty Rough Water In My 32 Active Thunder With 500 Hps And Bravo 1 Drives Was Running About 65 Mph And Felt The Boat Slow Down So I Shut Down And 1 Drive Has No Forward But Reverse Works Fine, If I Shift It In Forward And Try To Spin Prop IT Spins Free No Noises At All, But If I Try To Spin It Backwards When It Should Lock It Does Not And It Gets Tight Then Loose (Clutches Maybe.
Thanks For Any Help
Thanks For Any Help
#5
Registered
Join Date: Jun 2001
Location: Lehigh Valley, Pennsylvania
Posts: 1,567
Likes: 0
Received 0 Likes
on
0 Posts
Raystown is just days away! Tic Toc Tic Toc! Time for the backup drive!!!
All you need is one drive to get you to and from the cove!!!
hehehehehe
Got a number for your groups houseboat yet?
All you need is one drive to get you to and from the cove!!!
hehehehehe
Got a number for your groups houseboat yet?
#6
Registered
Thread Starter
Join Date: Jul 2002
Location: pa
Posts: 2,233
Likes: 0
Received 0 Likes
on
0 Posts
#7
Registered
Join Date: Apr 2007
Posts: 223
Likes: 0
Received 0 Likes
on
0 Posts
It's in the upper. Possible the floor of the driven gear. Why don't you send the drive to us we can turn in around very quickly. We are a Merc. Service center. Give me a call at;
954 237 0332
954 237 0332
#9
Registered
Thread Starter
Join Date: Jul 2002
Location: pa
Posts: 2,233
Likes: 0
Received 0 Likes
on
0 Posts
so to take a look i dont need to pull the drive , just the top cap and if it is that then do you need to pull the drive and tear it down orcan you do it from the cap. nalso is there a 3 bolt plate you can remove and see the shift componets.
thanks
thanks
#10
Registered
Thread Starter
Join Date: Jul 2002
Location: pa
Posts: 2,233
Likes: 0
Received 0 Likes
on
0 Posts
pulled upper cap and plate with 3 bolts on the back and as far as i can tell everything looks fine all gears shift arm is working no metal filings in oil. is there something i can check mor thorough while im in there. thanks