Kaama Surface Drive HELP !
#1
Registered
Thread Starter
Join Date: Jun 2009
Location: Pickerington, Ohio
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Kaama Surface Drive HELP !
I have a 40' Formula with Kaama Surface Drives. I severly damaged one when the bearing came apart. I am looking for information on these unites or parts.
#2
Registered
Join Date: Sep 2005
Location: Syracuse, NY
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
What bearing went bad and where is the damage. I had a Kaama boat a few years back and the bearings in one of the transom assemblies went bad. The assembly got all torn up so I removed both off the boat and had a machine shop make a sleeve for the torn up one, using the good assembly as a template. It worked well and I never had an issue with it!! Not sure if this helps or not!
#4
Registered
Join Date: Sep 2005
Location: Syracuse, NY
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
It was so long ago I don't remember what the cost was (few hundred dollars maybe). The turn around time depends on the machine shop you take it to. If I remember correctly it took my shop about a week to get it done. I pulled the drives and transom assemblies out myself!
#5
Registered
Thread Starter
Join Date: Jun 2009
Location: Pickerington, Ohio
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Your advice has proven to be very helpful. It looks like we will be out about 2 weeks. We are not sure of the cost at this point but still very pleased with the interest in the repair and the cost will be what it will be. All this being far better than nothing. Through this whole process we have assembled a group of people that could possibly produce casting molds for the housings and the rubber boot. We'll see. Thanks again for your help
#6
Charter Member #232
Charter Member
There are a few boot threads going in the Formula area. If you find something boot wise let them all know and you can probably get the cost down per unit.
__________________
Put your best foot forward!
Put your best foot forward!