496 Mag impellar housing???
#1
Registered
Thread Starter
Join Date: May 2009
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
496 Mag impellar housing???
I remember reading somewhere that there is an identical pump like the one on a 496 but made of diffrent material (NON BRASS). It will work on the 496 you just have to use original brass rear plate ( with sensor) and mounting bracket. Has anyone heared of this? if so what was the brand and part number for that pump?
Thanks,
Will
Thanks,
Will
#2
Registered
Join Date: Mar 2009
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
I remember reading somewhere that there is an identical pump like the one on a 496 but made of diffrent material (NON BRASS). It will work on the 496 you just have to use original brass rear plate ( with sensor) and mounting bracket. Has anyone heared of this? if so what was the brand and part number for that pump?
Thanks,
Will
Thanks,
Will
#3
Registered
Thread Starter
Join Date: May 2009
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Pump replacement
Ive seen the rebuild kit from R&R but read on a forum about a similar pump that can be bolted on by changing rear plate. Pump was signifantly less then merc pump . I have been searching all 496 water pump post but can not find it again.
#4
Registered
Join Date: Jan 2004
Location: San Diego, California
Posts: 2,777
Likes: 0
Received 6 Likes
on
6 Posts
To our knowledge at Raylar there currently is no water pump housing on the aftermarket to replace the Mercury brass housing, just the end plate kits and impellear replacements. Sorry
Best Regards,
Ray @ Raylar
Best Regards,
Ray @ Raylar
#5
Registered
Join Date: Mar 2009
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
#7
Registered
Thread Starter
Join Date: May 2009
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
for some reason i remember reading about a similar jabsco pump with matching front half. if im not mistaken that just needed the back plate mounted to it with sensor and it would work.