What oil pan to use?
#1
Charter Member #34
Charter Member
Thread Starter
Join Date: Oct 2000
Location: Beautiful North Carolina
Posts: 7,151
Likes: 0
Received 1 Like
on
1 Post
What oil pan to use?
What brand oil pans do you guys like to use?
I'm looking for recommendation for marine application, 540 CI with Dart block.
Thank you
I'm looking for recommendation for marine application, 540 CI with Dart block.
Thank you
#2
VIP Member
iTrader: (1)
I assume you have 1 piece RR. main seal.
Here is what I used on my 540's
http://www.cantonracingproducts.com/...ion&key=18-362
I also installed these so no more dry starts:
http://www.cantonracingproducts.com/...ion&key=24-016
Smitty
Here is what I used on my 540's
http://www.cantonracingproducts.com/...ion&key=18-362
I also installed these so no more dry starts:
http://www.cantonracingproducts.com/...ion&key=24-016
Smitty
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
#3
Platinum Member
Platinum Member
I have a few of the Keith Eickert cast aluminum pans.
New they were over a grand each. think you can get them around $700 each now.
If you like I will let two of them go for $400 each.
They are either 12 or 14 quart,.......can't remember off hand.
Jon
#4
Charter Member #34
Charter Member
Thread Starter
Join Date: Oct 2000
Location: Beautiful North Carolina
Posts: 7,151
Likes: 0
Received 1 Like
on
1 Post
I assume you have 1 piece RR. main seal.
Here is what I used on my 540's
http://www.cantonracingproducts.com/...ion&key=18-362
I also installed these so no more dry starts:
http://www.cantonracingproducts.com/...ion&key=24-016
Smitty
Here is what I used on my 540's
http://www.cantonracingproducts.com/...ion&key=18-362
I also installed these so no more dry starts:
http://www.cantonracingproducts.com/...ion&key=24-016
Smitty
Dart uses the 2pc rear main seal.
Thanks
Mark
#5
VIP Member
iTrader: (1)
Mark
Canton also makes pans for the 2 piece rr main seal. They have all kinds of pans.
Are you looking for steel or aluminum. I went with steel to save $$$$$.
Dave
Canton also makes pans for the 2 piece rr main seal. They have all kinds of pans.
Are you looking for steel or aluminum. I went with steel to save $$$$$.
Dave
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
#9
VIP Member
iTrader: (1)
Mark
Make sure you will have enough clearance under those KE pans. The stringers in our boats are close to the bottom of the motors.
Smitty
Make sure you will have enough clearance under those KE pans. The stringers in our boats are close to the bottom of the motors.
Smitty
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com