Grab Rails? Bow Rails? Where To Get them?
#1
Registered User
Thread Starter
Join Date: Dec 2009
Location: Ft. Riley, Kansas..(Milford Lake)
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Grab Rails? Bow Rails? Where To Get them?
On a lot of the new boats they will have the "center" bar running the length of the bow it looks like one giant grab rail, i want to install 2 on the front of my boat and was wondering if this is a custom thing or can you buy them whole somewhere? Oh ya and i have no idea what they are called...if you could help..Thanks -Mike
#2
Charter Member # 55
Charter Member
I'm sure these guys could make you what you need. They made a custom bezel for me.
http://www.offshorenortheast.com/
I do have 2 long straight rails that are about 9 ft long that are powdercoated purple that I would sell, but shipping would be very expensive. Where are you located????
http://www.offshorenortheast.com/
I do have 2 long straight rails that are about 9 ft long that are powdercoated purple that I would sell, but shipping would be very expensive. Where are you located????
#5
Registered User
Thread Starter
Join Date: Dec 2009
Location: Ft. Riley, Kansas..(Milford Lake)
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Griff, The ones you have is what I am looking for and i appreciate all the help I'm actually stationed at Ft. Riley Kansas and I see your in Omaha I could deff. make the trip to get the rails. I just have to measure the boat today to make sure they will fit. Thanks Again
#7
Charter Member # 55
Charter Member
Mine were the original rails that were used as grab rails down the sides of the fairing on my 32 AT. I looked and they are actually closer to 10 feet long. They are just like what is on the sides of the older Sonics. They could be shortened by a good welder or they could easily be cut and capped on one end. The only thing is that they use 4 mounting bolts at each brace location that would be visible from the top. $100 for both of them.
#8
Registered User
Thread Starter
Join Date: Dec 2009
Location: Ft. Riley, Kansas..(Milford Lake)
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Thanks griff for the offer but i think i am going to keep searching i want to try and get them flush with the top deck so no bolts are visisble.
#10
Registered User
Thread Starter
Join Date: Dec 2009
Location: Ft. Riley, Kansas..(Milford Lake)
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
got this pic to kinda show what i'm looking for not a great one but you'll get an idea of what i want. Would like to install on both sides of my bow hatch and remove the old rails and kinda put a new school look on an old school boat