454 with trs
#1
87cafe
VIP Member
Thread Starter
Join Date: Jan 2009
Location: gulfport ms
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
454 with trs
ive have dropped a valve in #3 cylinder. i need to pull my engine, i have an 454 with br transmission. would i need to seperate at the bell housing, or at the transmission to pull the engine, whats quickest or easiest way to do this? any info would be greatful
#3
Registered
iTrader: (4)
Originally Posted by [email protected]
ive have dropped a valve in #3 cylinder. i need to pull my engine, i have an 454 with br transmission. would i need to seperate at the bell housing, or at the transmission to pull the engine, whats quickest or easiest way to do this? any info would be greatful
Did the valve take out a piston?
#4
87cafe
VIP Member
Thread Starter
Join Date: Jan 2009
Location: gulfport ms
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
thanks much, yes the valve decentagreted my piston beat to hell and back cylinder wall cracked, i already have another block just need to get this one out, thanks again for the help!
#6
87cafe
VIP Member
Thread Starter
Join Date: Jan 2009
Location: gulfport ms
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
#8
Registered
iTrader: (4)
Don't you need the drive/transmission alignment tool if you remove the tranny? I have one drive that takes 2 people and 2 hours to put on, it is a B!tch!!! The other TRS drive I can put it on and bolted up in 15 mins by myself.
Last edited by Rookie; 05-15-2010 at 07:22 PM.
#9
Just did mine take out with trans took me about 2.5 hours at my shop with air tools and a chain fall. I bagged all my bolts and marked each one so assembly is easy. Im not sure about an Hour not sure how thats possable even with air tools and chaion fall.
-Mike
-Mike
#10
87cafe
VIP Member
Thread Starter
Join Date: Jan 2009
Location: gulfport ms
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts