Headers and reversion
#1
Headers and reversion
Just switched from gil manifolds to hardin shorty headers. Gettings lots of reversion now and all the milk that goes with it. Is it common to get this problem with all types of headers. The tails are 28 in long. Is going semi dry and longer all I can do. I really doubt hardin will refund my 5 grand. I should have done more research. Opinions?
#2
Registered
iTrader: (2)
Join Date: Aug 2005
Location: Between A Womans Leggs in IL
Posts: 6,306
Likes: 0
Received 1 Like
on
1 Post
fIXX
Just switched from gil manifolds to hardin shorty headers. Gettings lots of reversion now and all the milk that goes with it. Is it common to get this problem with all types of headers. The tails are 28 in long. Is going semi dry and longer all I can do. I really doubt hardin will refund my 5 grand. I should have done more research. Opinions?
http://www.keitheickert.com/detail.aspx?ID=2586
Last edited by FIXX; 07-19-2010 at 06:00 PM.
#3
Registered
Join Date: Apr 2013
Location: MARYLAND
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
do the turbolators make that much of a difference. I run the same headers and have the same issue but only on one of my motors. could it be the rust holes in the turbolators? low idle? good luck brother....I have the same issue.