shift lever question
#1
Registered
Thread Starter
Join Date: Oct 2006
Location: Cincinnati,Ohio
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
shift lever question
I've got morse shifters and throttles and i keep having an issue with my port shifter slipping back toward the neutral position( an 1inch or 2) while under way. The shifter never takes the drive out of gear but it annoys the sh!t out of me. Is there an adjustment to stop it from creeping back?
#4
Registered
After looking at the original post, my problem is not the shifter, but the throttle. The shifters are quite stiff and I would like to ease them up a bit. Is there adjustment for the throttles and the shifter? I took the whole shifter assembly out and see that it is actually one piece. Looks like ALOT of little parts to go flying if I try to disassemble it.
#5
Registered
Join Date: Jul 2004
Location: Hobe Sound, FL
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Not too had to disassemble...do it on a clean bench after you remove from the boat/cables. If you have stiff throttles/shifters, you will probably need to replace the cables. These get stiff over time and there is no fix besides replacement. My buddy did this and I just got done doing it on my boat.