242ls fuel sending unit
#1
Registered
Thread Starter
Join Date: Aug 2008
Location: st. louis mo
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
242ls fuel sending unit
my sending unit is no good, it was bouncing from e- 3/4 tank while not moving then I tried checking for a good connection and I fixed it so good it just stays on e my question is do i have to pull up the center floor section to pull it out? I have an access hole but it is off to the side of access. Is there anything I need to do ,other then remove screws, when pulling it and reinstalling it?
#5
Registered
iTrader: (4)
You can get it out without removing the floor... Just remove the screws and pull it out. If you have a 242 SS you may have to pull the floor panel but the LS will come out with everything in place!