Need help with drive height
#1
Registered
Thread Starter
Join Date: Apr 2011
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Need help with drive height
Hello boaters, I have a 28 saber that I plan to install a pair of bravos and stellings 12in setback boxes. I'm not sure were to put the propshaft in relation to the bottom of hull? Thanking you in advance brian.
#2
Registered
Seems like most guys with boxes have the propshaft centerline 3.5" to 4.5" deep. I have a post on this with a ton of feedback, I will pull it ttt for you. Feel free to post input there.
#5
Platinum Member
Platinum Member
30' Scarab w/Bravos on Stellings boxes. The propshafts are about 2" below the bottom. It is reasonable getting on plane with B1 props. What HP will you have and what is the MPH are you expecting?
#7
Platinum Member
Platinum Member
Measure directly in front of the drives. One other dimension to check would be the "new" clearance between the flame arrestor and and the engine hatch.
#8
Registered
Thread Starter
Join Date: Apr 2011
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
The engine hatch cover was going to have to modified someday. I have blowers and intercoolers that I plan on using when the time is right. Just going to use a carb intake setup at first. Even the stelling exhaust manifolds have elbows that are taller then most .Don't like losing the sun pad!