Best props for a 29' Scarab w/350mags???
#2
Registered
Try an old set of 23 cleavers, you have to baby them to get on plane but they will give you the top end you want if the motors have been worked on , they have to be trimmed when you get on plane. good luck ....
Jim
Jim
#4
Registered
Join Date: May 2004
Location: Clear Lake Shores, TX
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
I was wondering the same thing
I have twin 350s on my 29 with Alpha ones. The props are 4 bladed. Not sure which ones as they came with the boat. I doubt my boat can go 60 but I ride it in open ocean. I've haven't opened it up yet either. 4000RPM is all Ive seen so far. GPS was reading 50MPH
#6
Registered
Thread Starter
Join Date: Feb 2011
Location: lexington sc
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
I run it yesterday in cool air and hit 62 on GPS @4700rpm. This is with burred up 23's on alpha's and nose cones that need to be reworked a little due to the filler chipping out. I don't think I could spin 25's. My best bet may be some 3 blade labbed 23 mirage Plus's or some 4 blade 21's. Any thoughts on the 4 blades?
#7
Registered
Join Date: Aug 2010
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
I run it yesterday in cool air and hit 62 on GPS @4700rpm. This is with burred up 23's on alpha's and nose cones that need to be reworked a little due to the filler chipping out. I don't think I could spin 25's. My best bet may be some 3 blade labbed 23 mirage Plus's or some 4 blade 21's. Any thoughts on the 4 blades?
For my aplication i will love better the 4 blade, I have ran a Mirage Plus 25p 3 blade before and the 3 blade is less faster than a 4 blade in my situation but the 3 blade is the prop that the boat come with when i have buy it so i dont know if the prop have been alredy get repaired or modified i can turn it only at 4850-4900 rpm and 3 mph less faster.