525efi vs 525efi with Whipple resale value
11-05-2012, 12:01 PM
#2
Charter Member # 55
Charter Member
Considering the kits are about 15k each , I would say it increases value, but it also limits the amount of potential buyers, so it may be a harder sell.
11-11-2012, 03:24 PM
#4
Platinum Member
Platinum Member
Join Date: Jul 2008
Location: Little River SC
Posts: 931
Likes: 0
Received 0 Likes
on
0 Posts
My question would be; was the engine built around using the Whipple, or was it a bolt on after wards?
I am by no means, questioning the Whipple, if it's boosted power the engine is not going to go the distance of the stock 525 efi.
I am by no means, questioning the Whipple, if it's boosted power the engine is not going to go the distance of the stock 525 efi.
11-11-2012, 06:28 PM
#5
Registered
What would be the deal breaker for me would be needing premium fuel. Since there is no place to purchase it on the water here (Puget Sound) that I know of that would mean I'd have to put the boat on the trailer everytime I needed fuel (it takes a lot of 5-gallon cans to fill a sportboat). As far as the additional stress on the 525 from the Whipple I do not have the knowledge to respond to that. With about 5% increase per pound of boost the performance would be awesome!
11-11-2012, 07:49 PM
#7
Charter Member #1171
Charter Member
When Im shopping, anything lesst then 100% stock and I dont even click on the ad.
You may know or think you did it right,,,,,I dont
But thats just me.
You may know or think you did it right,,,,,I dont
But thats just me.
__________________
I want to live in a world where a chicken can cross the road and not have its motives questioned.
I want to live in a world where a chicken can cross the road and not have its motives questioned.
11-11-2012, 08:51 PM
#8
Registered
I would be leary of any boat that has had a super charger/ blower on it. If not set up properly, the engine could be short lived. On the fip side, if you plan on having it re-built, it's nice to have the hardware to make some power.
11-12-2012, 10:36 PM
#10
Registered
Join Date: Sep 2012
Location: Lake Winnebago
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Did merc make a 525 that was a s/c motor? I looked at a profile that had 525 badges on the motors and it looked to be factory s/c not aftermarket? I don't know if this what bluber is asking about or was this a dealer instal after the fact?
