add O2 bung in Keith Eckert aluminum headers
#1
Registered
Thread Starter
Join Date: Mar 2008
Location: Edmond, OK
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
add O2 bung in Keith Eckert aluminum headers
Does anyone know if you can just drill and tap into the "collector" area of the KE aluminum headers to install an O2 sensor?
I don't have any length to install them in the tailpipe.
Thanks
I don't have any length to install them in the tailpipe.
Thanks
#3
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
You should make a 1" alum spacer for between the tailpipe and header. Then at 3 oclock drill and tap the hole for the sensor. I do not believe you can do what you suggest even though there are pads that look like you could cast into the header.