454 carb thunderbolt IV... timing all over??
#1
Gold Member
Gold Member
Thread Starter
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
454 carb thunderbolt IV... timing all over??
I set my total advance at 34 degrees...... after around 4000 the timing jumps all over the place, I cannot remember if this has done it with multiple boxes since I have so many different issues to figure out....I have new coil, and new pick up, I am trying to find another ingnition module but I swear it did this with 2 different ones......
I am also thinking of ditching the merc ignition and going with something else....
What would be any other suggestions? this engine is very sluggish to go from 4500-5000 takes a minute catch up... does not feel as strong as port goes right to 5000
I am also thinking of ditching the merc ignition and going with something else....
What would be any other suggestions? this engine is very sluggish to go from 4500-5000 takes a minute catch up... does not feel as strong as port goes right to 5000
#3
Gold Member
Gold Member
Thread Starter
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
I run new small module on that engine, a old box on other one, I have a buddy with a few extras, I plan to grab one from him to use..... the connections are good as well as I ran new ground from battery to be sure...