Where can I find plastic mipples that go into valve covers for venting??
#1
Where can I find plastic mipples that go into valve covers for venting??
Some how I lost two nipples and hoses that vent the valve covers to the flame arrestor. These are the same size as stock valve covers. The hose is 5/8 and I believe the plastic nipple is 3/4.
Any ideas?
Any ideas?
#2
Registered
Join Date: Nov 2005
Location: Wayland, MI
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
#5
Only the Best Will Do!
Join Date: Nov 2004
Location: Palm Coast, FL
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
#6
Registered
The push in breathers should have worked. They all use the same size VC hole. Sometimes the rubber grommet that is inserted into the VC can really be tight and seem impossible to push the breather into, but they should all be the same. If you have an old grommet lying around use that instead of the new one. May be easier.
#7
Registered
Perhaps you are trying to use the hole that a pvc valve would normally go into. In which case yes you are correct a breather would not fit. Any auto parts store should have the plastic piece your looking for. Probably hanging up on a revolving rack that has little door clips, grommets,etc.