blackta

My boat has captains choice and won't work with my headers so I was going to take the y pipe off. Where can I get a block off plate for it for bravo 1 outdrive? If from marina does anyone have part #

Cole2534

iTrader: (1)

Aqui-

http://www.keitheickert.com/p-13860-...lications.aspx

COOPS

iTrader: (2)

I have one used if you want it 20.00 shipped

Expensive Date

CP performance makes really nice ones were you can leave the Y pipe in. I have a used set $30.00 shipped cont. US

Budman II

iTrader: (1)

Are you talking about the caps that go over the ends of the Y-pipe where the exhaust hooks up?

COOPS

iTrader: (2)

I have the exact one listed

http://www.keitheickert.com/p-13860-...lications.aspx

You have to pull the y-pipe to install it. It bolts to the inner transom plate to block the exhaust exit under water.

Expensive Date

[ATTACH=CONFIG]523602[/ATTACH] No these you use the rubber coupler, they go inside the coupler.

dereknkathy

engine has to come out for anything but expendate's setup. then just get 3 feet of hose cut in half to run where diverters were.

Budman II

iTrader: (1)

I did the el cheapo redneck solution to the problem - similar to what Expensive Date has. Went to Lowes and got some rubber plugs in the plumbing department, installed them in the rubber boots with some Right Stuff to seal them up. Ran some stainless screws through them for insurance that they couldn't pop out. Ran two years like this without leaking a drop. Planning to put SC back on, so it was a temporary solution, but it worked fine.