trouble with 525 sc
#1
Registered
Thread Starter
Join Date: May 2014
Location: Sarnia, Ontario
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
trouble with 525 sc
had a push rod come out..all rockers were adjusted properly,push rod is not bent and no other damage done..what happened? this happen to anyone else??
#5
Registered
Pressed in rocker stud pulling out?
#9
Registered
Thread Starter
Join Date: May 2014
Location: Sarnia, Ontario
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
yes poly lock was still in place..when removed i left set screw in original position and reassembled with 3/4 turn on lifter..collapsed lifter?? brand new crower rollers..
thought maybe something went through and held the exhaust valve open, but you think you would have seen damage in the blower..would like to test run the motor again but scared of breaking something..
thought maybe something went through and held the exhaust valve open, but you think you would have seen damage in the blower..would like to test run the motor again but scared of breaking something..
Last edited by Cujo; 05-30-2014 at 03:13 PM.
#10
Registered
iTrader: (1)