New Oil Coolers? Yes or No?
#1
Registered
Thread Starter
Join Date: Aug 2012
Location: Collierville, TN and Pickwick Lake
Posts: 2,291
Received 394 Likes
on
164 Posts
New Oil Coolers? Yes or No?
What's the concensus? One motor burned a hole in a piston due to detonation. Hammered the crankshaft bad enough to crack it at one of the mains so the bearings were pretty hammered. I cleaned the coolers very well, flushed both ways numerous times and for several minutes with very hot soapy water using a pressure washer with the tip removed and plumbed directly to the hose fitting, (low pressure). I was about to install the motors and started thinking "what if". So what have you done or what would you do in a similar situation.
Last edited by payuppsucker; 06-09-2014 at 05:40 PM.
#4
Registered
I wouldn't use them.