What happened
#1
Registered
Thread Starter
Join Date: Sep 2011
Location: Moscow OH.
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
What happened
Only 12.6 hours on the clock. Builders is standing behind his work and going to fix it. Just looking for some of the engine builders opinions. Most of the hours are cruising 3500rpm of course a few wot passes 5400rpm MSD ignition and soft touch limiter with a 5800 plug.
.
Last fall different cylinder http://www.offshoreonly.com/forums/g...?highlight=598.
.
Last fall different cylinder http://www.offshoreonly.com/forums/g...?highlight=598.
Last edited by the mayor; 09-20-2015 at 12:00 PM.
#5
Registered
Join Date: Nov 2008
Location: Winchester, TN
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Ouch! Were the heads new assembled units? If so it my have had a tight guide and the valve seized. Props to your builder for standing behind his work. In the time we live in it seems we hear more horror stories than good reputable people. Hope it all works out.
#6
Registered
looks a little lean compared to the other cylinders.to much heat will stick that valve..could also come down to water flow thru the cylinder head.2 engines down,,something in the set up is amiss.
#7
Registered
Thread Starter
Join Date: Sep 2011
Location: Moscow OH.
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
He used the block head castings crank and rods everything else was new.
#8
Registered
Thread Starter
Join Date: Sep 2011
Location: Moscow OH.
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
Water temp barely over 100 oil temp 185 to 190.
Different cylinder than the first time opposite side this time.
Last edited by the mayor; 09-20-2015 at 08:04 PM.
#9
Registered
Thread Starter
Join Date: Sep 2011
Location: Moscow OH.
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts