6.2 whipple stage 1 ecm reflash
#2
What are you looking to gain? My initial gut response would be...don't do it. 6.2s need a ton more work than a tune to perform better. Trust me. I've done it.
Just tuning assumes the stock tune is super far off optimal and you can get gains from that. I don't believe this to be the case.
Just tuning assumes the stock tune is super far off optimal and you can get gains from that. I don't believe this to be the case.
#3
Registered
Thread Starter
ecm flash raises limiter to 5600 from 5200. Gain of 10% power =30+ horse. The goal would be to try and turn a few hundred more rpm, and pick up some top end. So long question short would the flash result in 2-300 more rpm from my existing set up?
#5
It likely won't get you there. My 6.2s are 400 hp and I'm not to my limit of 5600 yet.
I have some labbed props that I expect will do it when I get around to putting them on.
So at minimum if you do it, you need labbed props.
I have some labbed props that I expect will do it when I get around to putting them on.
So at minimum if you do it, you need labbed props.