Valve cover breathers Push in/Stack type???
02-26-2016, 09:09 AM
#1
Registered
Thread Starter
Join Date: Jan 2016
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Valve cover breathers Push in/Stack type???
Got new valve covers for my 434. 1- is a pcv necessary? 2- Can i run a good push in valve cover breather for both sides or is a screw down "stack type" necessary?
Previous setup from previous owner when motor was slightly more mild had a pcv on starboard and catch can/puke tank on port. would like to clean it up a bit with 2 good push in breathers.
http://www.jegs.com/i/Earl's/361/343...FcgjgQodJMQK5g
would have them either dipped or powder coated. I have a set of Eddie Marine stacks but they seem like a real pain and bolt in through bottom. whats the odds of the bolt coming out and being sent through the motor till it stops?
Previous setup from previous owner when motor was slightly more mild had a pcv on starboard and catch can/puke tank on port. would like to clean it up a bit with 2 good push in breathers.
http://www.jegs.com/i/Earl's/361/343...FcgjgQodJMQK5g
would have them either dipped or powder coated. I have a set of Eddie Marine stacks but they seem like a real pain and bolt in through bottom. whats the odds of the bolt coming out and being sent through the motor till it stops?
