K1 tech vs molnar
#1
Registered
Thread Starter
iTrader: (7)
K1 tech vs molnar
Just wondering if anyone has used any of the molnar cranks and rods. From what I understand Tom I think it is split off from k1 and went on his own. Any insight on this would be great.
#3
Registered
Thread Starter
iTrader: (7)
Tks for the response. I see there here in Michigan and would like to try them out on my 598 build. They look like there along the line of all the other middle of the road rods and cranks. I'm going to call and make sure their cranks are close to spot on and finish ground here in MI. I will keep you informed with my conversation with hem as well. I just don't want my machine shop giving me the evil eye when I drop off rotating assm for balancing and checking all tolerances etc.
#5
Registered
Second hand info, but I hear good things. Local machinist has been fairly impressed by them as far as accuracy/tolerance goes. Did some research on them for a build I was considering and probably would have went with them. On par or better than other China casting/forging pieces finished in US.
#9
Registered
Thread Starter
iTrader: (7)
Didn't call dick at More Power cause he woulda sold me all top of the line Callie's. Can't swing that at the moment.