any jet ski tech's here
06-01-2016, 08:50 AM
#1
Platinum Member
Platinum MemberThread Starter
iTrader: (6)
any jet ski tech's here
I just bought a 2006 Sea-Doo GTI 4-tec, was told speedo doesn't work, does this thing have a paddle wheel underneath for this to work ??
Gold Member
06-01-2016, 09:01 AM
#3
Platinum Member
Platinum MemberThread Starter
iTrader: (6)
do you have to pull the under plate off to get to it, I didn't see it when looking under it
06-01-2016, 09:27 AM
#5
Platinum Member
Platinum MemberThread Starter
iTrader: (6)
thanks B 3
06-01-2016, 12:28 PM
#6
Charter Member
There should be a paddle wheel on the back end of the ski....on my GTX its on the ride plate on the left rear corner when you are looking at the jet pump from the back.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
VIP Member
06-01-2016, 02:31 PM
#8
Platinum Member
Platinum MemberThread Starter
iTrader: (6)
There should be a paddle wheel on the back end of the ski....on my GTX its on the ride plate on the left rear corner when you are looking at the jet pump from the back.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
06-01-2016, 02:53 PM
#9
Registered
06-01-2016, 02:59 PM
#10
Just remembered: I bought a Yamaha GP1200 several years ago and the paddlewheel's wire that went up to the dash/computer had a nick in it, and went bad. I was able to buy the whole part on eBay off of a parted out PWC pretty easily; and install it. It worked fine.
