TRS to Bravo Flywheel help
#1
Registered
Thread Starter
iTrader: (4)
TRS to Bravo Flywheel help
I am going to bravos with. At the present time I use top mount starters.
To use bottom mount starters do I need to flip my flywheels 180*?
I have Gen V blocks. I don't know the internal vs external balancing stuff.
Thanks
To use bottom mount starters do I need to flip my flywheels 180*?
I have Gen V blocks. I don't know the internal vs external balancing stuff.
Thanks
#7
Registered
Use a blunt nose chisel or air chisel and work your way around ring gear evenly until removed. To install , make sure flywheel is clean of paint and rust. Clean inner surface of ring gear.
To make things easier , you can cool flywheel in freezer or ice down. Heat ring gear in household oven ( if not super clean , gear will smoke up house) or heat with torch. With gloves of course , drop ring gear in to position on flywheel. Make sure its fully seated and your done!!! Takes about 1/2hr total time to change ( less if already clean) Good luck!!
To make things easier , you can cool flywheel in freezer or ice down. Heat ring gear in household oven ( if not super clean , gear will smoke up house) or heat with torch. With gloves of course , drop ring gear in to position on flywheel. Make sure its fully seated and your done!!! Takes about 1/2hr total time to change ( less if already clean) Good luck!!
#9
Registered