What to do With My MK Cams
#3
Charter Member # 55
Charter Member
There are also 100's of others that are running MK cams with good results.
I've got no dog in this fight so carry on
#5
Registered
I have a few more hours than you do with Bob M cams and also have no issues. I have called Cam Motion and I am go to go as far as I am concerned. My cams are not a lot different than a 525 efi and everyone seems to like them so I am not going to worry about them.
#9
Gold Member
Gold Member
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,634
Likes: 0
Received 204 Likes
on
132 Posts
Many more then a handful with issues, and most seem to be recent and specs like mine, a simple test would be to yank a distributor and you can at least see the 4 last lobes visually, takes 10 minutes you will know if you have issues, if it looks good run it till refresh time, many of the guys not having issues are less agressive on valve train... That's why no issues, my valve train is beat to you know what at 65 hours...
#10
Registered
iTrader: (8)
My MK SBC cam went in 2007 and was still running when I sold the motor to donzi matt a couple years back. Cam Motion billet roller 234/240 .580/.568 112+4. When engine was rebuilt last time, cam and lifter lobes were normal. Morel lifters. Motor made great power and GPS speeds were above expected for the setup. Like mentioned above inspect thru the distributor hole and if happy with performance leave it alone. My .02