800sc Valve Springs
#1
Registered
Thread Starter
Join Date: Feb 2001
Location: Baltimore,Maryland
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
800sc Valve Springs
Some imput wanted. I have a pair of Merc 800sc's with under 90 hours in my 95 Skater. They are original and have never been apart, they still have the seals on the intake bolts. I am thinking of replacing the valve spings this year just as routine maintance. I would probably use Isky 8005-A with their retainers and locks. Who has a set of these 800's, and how many hours are they good for, valve train, blowers,ect? Thanks, Paul
#5
Registered
Join Date: Oct 2000
Location: Fells Point MD
Posts: 532
Likes: 0
Received 0 Likes
on
0 Posts
Griff, on a lot of these BB heads, there are openings that will allow you to drop in a "hook" and pull the lifters out by their tie bar and reinstall them the same way. Most people fashion a few out of hanger size wire. Its a PITA but easier that pulling the blower, manifold etc. and reinstalling same.
#8
Platinum Member
Platinum Member
I want Lucy to help me work on MY engines.
I routinely drop fasteners and small parts (bolts and nuts) in the bilge and my big arms won't fit between the hardware to reach them.
I bet LUCY could bend over right there and reach those nuts. She might have to give a little wiggle, though, to get them to come out.
I'd even buy her lunch.
I routinely drop fasteners and small parts (bolts and nuts) in the bilge and my big arms won't fit between the hardware to reach them.
I bet LUCY could bend over right there and reach those nuts. She might have to give a little wiggle, though, to get them to come out.
I'd even buy her lunch.