Changing to new style exhaust shutter's... WTF?
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Nov 2002
Location: LONG ISLAND/LAKE MURRAY
Posts: 2,399
Likes: 0
Received 1 Like
on
1 Post
Changing to new style exhaust shutter's... WTF?
The old style which were all steel with 2 small rubber grommets were no longer available. OK.... went with new style pn#807166a1. Looks like a better set up but how the hell do they go in??? It looks as if the rubber ends need to attach to the shutter and slides in. Tryed a little grease, not happening! HELP?
#4
And sometimes you might have to take a little off the end so it goes down far enough to engage the 2 holes in the pipe. Make sure the flappers move freely too. Good Luck
Last edited by formula31; 04-13-2003 at 08:00 PM.