Tailstock/engine allignment question?
#1
Registered
Thread Starter
Join Date: Apr 2002
Posts: 4,215
Likes: 0
Received 0 Likes
on
0 Posts
Tailstock/engine allignment question?
Are there supposed to be some spacers or washers that go between the tailstock and the transom plate to allign the motor I dont remember taking any off but that was last October, and I could have easily forgotton
When I look through the gimbal at the tailstock from the outside of the boat, the tailstock seems to be sitting way lower than it should be
Any suggestions?
When I look through the gimbal at the tailstock from the outside of the boat, the tailstock seems to be sitting way lower than it should be
Any suggestions?
#2
Registered
Join Date: May 2002
Location: Tampabay Florida
Posts: 1,014
Likes: 0
Received 0 Likes
on
0 Posts
Spacer
Yes , there is a leather like material with a split/spring washer in the centre that goes between the bellhousing & transom plate. Hope this helps you out. Check Bam's Mercruiser parts section & you will see what ya need.
John
John
#3
Registered
Join Date: Oct 2000
Location: Wilmington,De,USA
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
split washer goes on top of gimbal inner plate, tailstock sits on top of this washer. Leather washer fits around outside of split washer
Last edited by David; 06-15-2003 at 06:31 AM.