Part Help - need old style trip pump reservoir with single bolt through bottom
#1
Registered
Thread Starter
Join Date: Jun 2001
Location: Chicago, IL
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Part Help - need old style trip pump reservoir with single bolt through bottom
I have an oildyne pump reservoir that is cracked and I need a new one. I have been told that they are no longer available through Mercruiser. This is the same pump that is sold to trim every bravo drive. I need the old style reservoir with a single bolt that holds it on from the bottom. The newer style has four bolts that holds in on from the top. I don't know if my pump has the 4 tabs or not. I will check soon. I just thought that someone has to have a few of these pumps sitting around.
Thanks!
Steve
[email protected]
Thanks!
Steve
[email protected]
#3
Registered
Thread Starter
Join Date: Jun 2001
Location: Chicago, IL
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Formula31. I may just try that. I don't have marine goop, but I wonder if 3M 5200 will work? It sticks to everything and I don't think oil will affect it.
Merc makes a retrofit kit but it is almost the cost of a new pump!
My pump was made in 1991. The new style bottle fits everything 1992 and later. Figures........
Steve
Merc makes a retrofit kit but it is almost the cost of a new pump!
My pump was made in 1991. The new style bottle fits everything 1992 and later. Figures........
Steve
#6
Registered
Thread Starter
Join Date: Jun 2001
Location: Chicago, IL
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Biggus - thanks, I will see if Sierra makes the old style reservoir.
mrv8outboard - How did you attach them??? My tank and the new tank look the same. However, my tank mounts with a single screw going up the center from the bottom. The new style tank looks the same, but it mounts with 4 screws from the top. My pump is one year too old to have a place for the 4 screws. I don't have the 4 holes on the mounting plate. After 1992, the holes were provided.
Thanks!
Steve
mrv8outboard - How did you attach them??? My tank and the new tank look the same. However, my tank mounts with a single screw going up the center from the bottom. The new style tank looks the same, but it mounts with 4 screws from the top. My pump is one year too old to have a place for the 4 screws. I don't have the 4 holes on the mounting plate. After 1992, the holes were provided.
Thanks!
Steve