Quick & Quiet Exhaust Issue
#1
Registered
Thread Starter
Join Date: Nov 2001
Location: Table Rock Lake
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
Quick & Quiet Exhaust Issue
Have a 96 Baja 272 with Quick & Quiet exhaust. I have to keep reseting the reset button for it to operate. It only stays on about 5 seconds then blows the circuit. Any one had this issue or have a recommendation?
Thanks, Jim
Thanks, Jim
#2
the system is drawing too much current, to determine the problem unplug one of the swiching servos and try the system, if it pops the breaker unplug another as well and reset the breaker and try again, and so on, untill you find the servo that is malfunctioning, if they all get un pluged and it is still poping the breaker then a wire from the switch is grounded somewhere, give it a wirl,
#3
Registered
Join Date: Apr 2001
Location: beaumont tx
Posts: 1,703
Likes: 0
Received 0 Likes
on
0 Posts
most of the time it is either a loose ground wire are the connection at each Corsa solenoid is corroded, unplug the connection and check it out clean with contact cleaner, this will give you a voltage drop and will blow the breaker, good luck
#4
Registered
Check the adjustment on the solenoid linkage. The solenoid is a 2 winding type. One uses high amperage to pull the plunger and lnkage in. The other one holds it in place. If the linkage is out of wack even a little bit, the solenoid stays on the pull winding, and will pop breakers.
Scott B
Scott B
Thread
Thread Starter
Forum
Replies
Last Post
kswest
General Boating Discussion
7
05-21-2006 10:21 PM