Help setting the timing on HP500EFI
#1
Registered
Thread Starter
Join Date: Feb 2003
Location: New Smyrna Beach, Florida
Posts: 2,697
Likes: 0
Received 1 Like
on
1 Post
Help setting the timing on HP500EFI
Do I need to use a DDT machine to set timing?? The manual says yes, but I set it without but the timing jumps around. Does the DDT lock in the timing?? Help me out, the damn thing is all back together but needs to be timed!!
#3
Registered
Join Date: Jan 2002
Location: McHenry, IL
Posts: 468
Likes: 0
Received 0 Likes
on
0 Posts
Dh-
You need to set the ecm into service mode to set the base timing. It can be done with a scan tool or by jumping some pins on the connector. I've got a scan tool that I'd be willing to loan you if you pay the shipping. You could probably do a search on timing to find out which pins to jump too.
Regards,
Mark S.
You need to set the ecm into service mode to set the base timing. It can be done with a scan tool or by jumping some pins on the connector. I've got a scan tool that I'd be willing to loan you if you pay the shipping. You could probably do a search on timing to find out which pins to jump too.
Regards,
Mark S.
#5
Registered
Join Date: Sep 2001
Location: Ontario, Canada
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
order the shunt tool from Mercury, this will only do timing if you want codes get the shunt tool from Renda or you will need the ddt or a lap top...the first is the cheapest