XR vs. XZ
#3
Registered
Can a standard bravo be updated with these gears, or is it in the housing also? If in the housing, can a XR bolt onto a stock bravo transom assemblyor is this different also??
#5
Registered
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
Dock Rat & del sol
You might want to check with Mike Mays at C.P. Performance. He set up a standard upper Bravo case with XR shafts/gears and an internal "power tower" for me that I keep for a spare. This does require some internal machining of the bravo case. Not cheap but supposed to handle big H.P.! The gimbal bearing needs to be changed to the larger XR bearing, otherwise everything will bolt up to standard transom assembly and lower housing.
You might want to check with Mike Mays at C.P. Performance. He set up a standard upper Bravo case with XR shafts/gears and an internal "power tower" for me that I keep for a spare. This does require some internal machining of the bravo case. Not cheap but supposed to handle big H.P.! The gimbal bearing needs to be changed to the larger XR bearing, otherwise everything will bolt up to standard transom assembly and lower housing.
Last edited by RedDog382; 11-26-2003 at 01:20 AM.
#6
Registered
Thread Starter
Join Date: Oct 2002
Location: Harrisburg, PA
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
So, other than perhaps a little more noise from the straight cut gears, the XR is the better choice.
To make a long story short, I'm wondering how long an XZ will live behind a Whipplecharged 500Efi. Single engine application if that matters. 30P 4 blade 1.50 ratio.
To make a long story short, I'm wondering how long an XZ will live behind a Whipplecharged 500Efi. Single engine application if that matters. 30P 4 blade 1.50 ratio.
#7
Registered
Join Date: Sep 2003
Location: Toledo, Ohio/Las Vegas, NV
Posts: 3,029
Likes: 0
Received 1 Like
on
1 Post
The XR will definately handle more power. Life span of either will depend on the weight of the boat and how you drive it. I put over 180 hours on Bravo 1's on my 311 Formula pushing 600 H.P. each without any problems. I guess I was lucky, but I always kept a spare upper on the shelf to ward off the evil spirits!
Last edited by RedDog382; 11-26-2003 at 02:14 AM.