Bronze/Brass impeller housing for Gen V/VI water/fuel pump assembly??

Reply Subscribe

Thread Tools

03-01-2004, 03:55 PM

Nordicflame

Registered

Thread Starter

iTrader: (4)

Join Date: Mar 2002

Location: Layton, Utah

Posts: 1,546

Likes: 3

Received 4 Likes on 4 Posts

Bronze/Brass impeller housing for Gen V/VI water/fuel pump assembly??

Does anyone know of a brass or bronze impeller housing that will fit on to the GEN V/VI as a direct replacement for the plastic Merc housing?

Thanks,
Dave

03-01-2004, 08:55 PM

marinetrans

Registered

Join Date: Nov 2003

Location: Fairhaven Ma

Posts: 833

Likes: 0

Received 0 Likes on 0 Posts

Are you losing 1 piece housings due the plastic melting where the impeller rides (end of housing)?

03-01-2004, 09:50 PM

DIAMONDPERFORMA

Guest

Posts: n/a

Jabsco makes one,not sure if fuel pump will bolt to it

03-01-2004, 10:27 PM

HARRISONMIRAGE

Registered

Join Date: Jan 2002

Location: HARRISON HOT SPRINGS B.C.

Posts: 194

Likes: 0

Received 0 Likes on 0 Posts

Marine trans I have noted with the new one piece housings the ends burn up as you said.The old three piece units with the stainless ends lasted better.Gotta admit the one piecers are easier to install.Dave I would be interested if you found a brass housing as it should limit water pump maintenance to impellers.