Danny_Ocean

Just purchased some Decko-Dot flooring. Cockpit floor area is relatively small (5' x 6'). What glue would y'all recommend? There was a post recently on this very subject, but I cannot seem to find it in search.

Thanks in advance,

D. Ocean
Pompano Beach, FLA

Danny_Ocean

.

KNOT-RIGHT

Just did my floor in pirelli Yello raised dots rubber flooring.

Used the two part epoxy available from the link below.
If you have rubber flooring beleave me this is what to use.

Follow the directions.

Good luck
Gerryhttp://www.rubberfloors.com/

Active Mike

Danny_O,
I would recommend the two part epoxy as well. Works great and holds well. I just put a Lonseal rubber floor down in my boat and that is what I used.

BRUCE SEROFF

I used contact cement and its holding up fine

Danny_Ocean

Will any two-part epoxy work? I have a bunch of West System left-over from recent hull repairs.

Contact cement? "Plain old" contact cement?

D. Ocean
Pompano Beach, FLA

BRUCE SEROFF

The contact cement used for formica applications.
Worked for me.