Go Back  Offshoreonly.com > Technical > General Q & A
35 Executioner w/ T-496HO's, Props?? >

35 Executioner w/ T-496HO's, Props??

Notices

35 Executioner w/ T-496HO's, Props??

Old 09-29-2004, 10:04 PM
  #1  
Rough Seas Lie Ahead
Gold Member
Thread Starter
 
Reckless32's Avatar
 
Join Date: Feb 2002
Location: Virginia Beach, VA
Posts: 2,465
Likes: 0
Received 0 Likes on 0 Posts
Default 35 Executioner w/ T-496HO's, Props??

A friend of mine recently purchased a 2004 35 Fountain Executioner with a pair of 496HO's He's running 32" Bravo props and banging the rev limiter regardless of fuel/pax load at sea level in salt water. Has anyone had this setup and if so, what props ran best? He was thinking of trying 34 labs, but feels he would give up too much of the hole shot & cruise not to mention running delicate blades in a tidal area.

Right now the boat runs up to about 78mph when the alarms start hitting and down trim is needed to drop the revs.
Reckless32 is offline  
Old 09-29-2004, 10:37 PM
  #2  
Platinum Member
Platinum Member
iTrader: (1)
 
articfriends's Avatar
 
Join Date: Jun 2004
Location: frankenmuth michigan
Posts: 7,140
Received 813 Likes on 373 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

your post isn't 100% clear,are you saying the boat goes 78 mph wot w/32 pitch's on rev limiter?If you are then assuming 496 ho's rev limiter is at 5200 your buds prop slip is almost 25%,somethings not right, possibly used props that were cut down?Please give more info,(topspeed mainly),Smitty
articfriends is offline  
Old 09-30-2004, 09:33 AM
  #3  
Registered
 
berns29scarab's Avatar
 
Join Date: Jul 2004
Location: Toms River, NJ
Posts: 7,141
Received 10 Likes on 7 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

what are the rpms when he's hitting the limiter and as far as MPH is that on a GPS ?
berns29scarab is offline  
Old 09-30-2004, 11:41 AM
  #4  
OSO Moderator
Charter Member
 
BillR's Avatar
 
Join Date: Oct 2000
Location: Virginia Beach, VA
Posts: 3,580
Likes: 0
Received 3 Likes on 3 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

Hitting rev limiter at 5150 hard.
Props are standard 32P Bravo's - 100% stock.
__________________
BillR

'00 Scarab Sport 302 CC
'02 Cigarette Top Gun TS
'02 PQ 340
'00 PQ 280
'98 Scarab 22
'97 Baja Outlaw 20
'72 Checkmate
'65 Glastron
BillR is offline  
Old 09-30-2004, 12:28 PM
  #5  
35/25
Guest
 
Posts: n/a
Default Re: 35 Executioner w/ T-496HO's, Props??

Do you know what ratio the drive is? I believe some of the newer boats with 496's have a 1.65 ratio rather than the 1.50. This would partially explain why the 32's are turning more rpm than would be expected. An Executioner with HP 500's and 28 pitch Bravos and 1.50 ratio will turn around 5200.
 
Old 09-30-2004, 01:56 PM
  #6  
Registered
 
p4-33's Avatar
 
Join Date: Jan 2003
Location: Gibraltar, MI
Posts: 1,026
Likes: 0
Received 1 Like on 1 Post
Default Re: 35 Executioner w/ T-496HO's, Props??

I'm with 35/25, with a 1.5:1 drive, a 28p should do it. The Hydro Quad IV 28p works well because a Fountain carries it's bow well on it's own. The Hydro has good stern lift qualities, so the combo of Fountain/Hydro makes the whole boat run light in the water, thus more speed.
p4-33 is offline  
Old 09-30-2004, 02:14 PM
  #7  
Platinum Member
Platinum Member
 
Ran-Dom 32's Avatar
 
Join Date: Sep 2002
Location: Lake St. Clair
Posts: 1,935
Likes: 0
Received 0 Likes on 0 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

I'm running 77-78 GPS 500hp's 5000RPM turning labbed 28 Bravo's 35 Classic single step - you #'s don't add up
Ran-Dom 32 is offline  
Old 09-30-2004, 02:50 PM
  #8  
OSO Moderator
Charter Member
 
BillR's Avatar
 
Join Date: Oct 2000
Location: Virginia Beach, VA
Posts: 3,580
Likes: 0
Received 3 Likes on 3 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

It is a 1.5 ratio
__________________
BillR

'00 Scarab Sport 302 CC
'02 Cigarette Top Gun TS
'02 PQ 340
'00 PQ 280
'98 Scarab 22
'97 Baja Outlaw 20
'72 Checkmate
'65 Glastron
BillR is offline  
Old 09-30-2004, 04:52 PM
  #9  
Registered
iTrader: (1)
 
Join Date: Dec 2001
Location: Indianapolis, Lake Cumberland
Posts: 3,903
Received 341 Likes on 119 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

The 496 Mags would have to supercharged to turn 32 Bravos on a 35 classic with a 1.50 drive at 5150 rpm.

No doubt he's running a 1.65 drive if the motors are stock. Either that or he's boating downhill
Marginmn is offline  
Old 09-30-2004, 04:54 PM
  #10  
Registered
iTrader: (1)
 
Join Date: Dec 2001
Location: Indianapolis, Lake Cumberland
Posts: 3,903
Received 341 Likes on 119 Posts
Default Re: 35 Executioner w/ T-496HO's, Props??

And I'll bet that thing really burns up the gas.
Marginmn is offline  

Quick Reply: 35 Executioner w/ T-496HO's, Props??


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.