installing offshore mounts
03-08-2005, 10:17 AM
#1
Registered
Thread Starter
Join Date: Oct 2000
Location: Sussex, WI
Posts: 543
Likes: 0
Received 0 Likes
on
0 Posts
installing offshore mounts
Planning on replacing my std merc mounts with offshore mounts.
Does anyone know of a jig that is available for setting up the L brackets and mounts in the boat before engine installation.
Other wise where would I be able to get a plastic block that I could use for setting everything up.
Does anyone know of a jig that is available for setting up the L brackets and mounts in the boat before engine installation.
Other wise where would I be able to get a plastic block that I could use for setting everything up.
03-08-2005, 10:57 AM
#2
speel chekk this fokker!
Charter Member
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
Re: installing offshore mounts
i did mine with a plastic block. Just measure to make sure its all even very carefully. when its all lined up clamp everything securly in place and drill the mounting holes. then bolt it in place.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
03-08-2005, 11:23 AM
#4
Registered
Join Date: Oct 2000
Location: Lombard, Il
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
Re: installing offshore mounts
Speedway motors has the plastic block:
speedway motors plastic block
Puder, did you do this on a bravo boat? I would think the engine coupler needs to be bolted on so you can use the alignment tool.
DS
speedway motors plastic block
Puder, did you do this on a bravo boat? I would think the engine coupler needs to be bolted on so you can use the alignment tool.
DS
